Flipper Zero Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
modified to fit the Flipper Zero. It requires the same 3M screws and I reuse the foam inserts from the shipping box
- Ocena
- 4,4 / 5
- Polubienia
- 1057
- Pobrania
- 7627
- Wydruki
- 71
- Wyświetlenia
- 70 197
- Oceny
- 55
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Public Domain
**9/26/22** Updated model that uses 4mm screws with larger hinges and a small insert for an SD card in the top shell. Enjoy!
Might revise the hinges since they seem like a weak point. I needed to drill the holes out a bit but other than that everything was an easy fit. To get the colored text, I printed using .2mm layer height and printed the text first. When it finished, I immediately ran the top lid right on the same spot without removing the text. The heights should line up just right to form a clean first layer but your tolerances may require some fiddling with settings. The video I followed for that trick is below.