Flipper Zero Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
modified to fit the Flipper Zero. It requires the same 3M screws and I reuse the foam inserts from the shipping box
- Rating
- 4.4 / 5
- Likes
- 1,057
- Downloads
- 7,627
- Makes
- 71
- Views
- 70,197
- Reviews
- 55
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Public Domain
**9/26/22** Updated model that uses 4mm screws with larger hinges and a small insert for an SD card in the top shell. Enjoy!
Might revise the hinges since they seem like a weak point. I needed to drill the holes out a bit but other than that everything was an easy fit. To get the colored text, I printed using .2mm layer height and printed the text first. When it finished, I immediately ran the top lid right on the same spot without removing the text. The heights should line up just right to form a clean first layer but your tolerances may require some fiddling with settings. The video I followed for that trick is below.