13mm Flux syringe plunger
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Syringe plunger with 13mm end for use in 10cc Amtech flux tubes. I was fed up with trying to use a pen or my finger to…
- Ocena
- 5 / 5
- Polubienia
- 39
- Pobrania
- 448
- Wydruki
- 8
- Wyświetlenia
- 1598
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Syringe plunger with 13mm end for use in 10cc Amtech flux tubes. I was fed up with trying to use a pen or my finger to push out flux, so I designed this!
I recommend orienting the large end of the plunger to sit on the print bed so there is less overhang. I have also made a version with a tapered end so it can be printed without supports.
Print Settings
Printer Brand:
RepRap
Printer:
Prusa i3
Notes:
If using the regular STL, make sure you have support enabled. Otherwise, you can use the No Overhangs version, just make sure that the wide end of the plunger is sitting on the print bed.
Category: Electronics