Beefy Ender 3 Filament Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Print it using supports from bed. And you will need two extra screws and two T-slot nuts. In my picture it shows two…
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 347
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Print it using supports from bed. And you will need two extra screws and two T-slot nuts. In my picture it shows two unused holes on top, I figured out they are too close to the other ones on the same corner. So I covered them but I could post one with them uncovered if anyone wants it. The tough ones to tighten are on the bottom! I added a second one (in Marble PLA)with one less screw hole in the bottom right to see if it stiffens up this part. STL without top is there if you want to make your own better! IS IT TOO MUCH? YES! IS IT STRONG? YES! IS IT UGLY? YES! IS IT NECESSARY? NO…