1 / 4
Panavise 315 Circuit Board Holder Rod End Cap — zdjęcie 1
1 / 4

Panavise 315 Circuit Board Holder Rod End Cap

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A end cap for the rod on a Panavise Model 315 circuit board holder.

Ocena
4 / 5
Polubienia
6
Pobrania
20
Wydruki
2
Wyświetlenia
232
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Share Alike

This is an end cap for rod on a Panavise Model 315 circuit board holder. The edges on mine were a bit sharp, so this sticks into the ends to blunt them.

The fit will be a bit tight, but a rubber mallet should help coax them in.

Printer: Ender 3 Pro w/ direct drive

Material: PLA or PETG

Rafts: Optional

Supports: No

Resolution: 0.15-0.2mm

Infill: 15% or higher

Shells: 2+

Notes: Print with flat side down on the print surface.

Tagi