1 / 4
Panavise 315 Circuit Board Holder Rod End Cap
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A end cap for the rod on a Panavise Model 315 circuit board holder.
- Rating
- 4 / 5
- Likes
- 6
- Downloads
- 20
- Makes
- 2
- Views
- 232
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Share Alike
This is an end cap for rod on a Panavise Model 315 circuit board holder. The edges on mine were a bit sharp, so this sticks into the ends to blunt them.
The fit will be a bit tight, but a rubber mallet should help coax them in.
Printer: Ender 3 Pro w/ direct drive
Material: PLA or PETG
Rafts: Optional
Supports: No
Resolution: 0.15-0.2mm
Infill: 15% or higher
Shells: 2+
Notes: Print with flat side down on the print surface.