Rebar Corner Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I made this simple corner bracket that holds a piece of rebar upright. I attached it to the back corners of my large planter and put chicken wire between them to act as a trellis for my peas. Netting also would have worked.
I pushed the rebar all the way to the bottom of the planter and just put one bracket at soil-level. It seems sturdy, but it might not be a bad idea to put one at the bottom as well. I already had stuff planted and didn't want to dig it up, so I didn't bother. We'll see if it matters. This mount attaches with two wood screws.
Print Settings
Printer Brand: Anycubic
Printer: All-metal Mega
Rafts: No
Supports: No
Resolution: 0.3
Infill: 40% Gyroid
Filament: Econofil by filaments.ca PLA Black
Notes:
I used PLA, but PETG or ASA would probably be a better idea if you have some.
Category: Outdoor & Garden