1 / 17
[WIP] CR10 standalone case (splitted)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This remix is currently 'work in progress' Surely a few things might change in the future ;) 2022-03-17…
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 50
- Wydruki
- 0
- Wyświetlenia
- 917
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (10)Wydruki i komentarze (Wydruki: 0) (Komentarze: 2)Remiksy (0)Kolekcje (17)Powiązane
**This remix is currently 'work in progress'
Surely a few things might change in the future ;)**
2022-03-17
LVC_SKR_1.3_1.4_PI4B_V3
- SSR passage position should be corrected, not printed/tested yet
- RaspberryPi standoffs redesigned to avoid the formerly needed support
- removed some holes at the split for an easier printing without support for the SSR hole
Danger letters v1
- Z axis extended to 1.2mm
SolidState_Cap_V2
- Widened the cap +2mm (maybe more is needed, will test later)
2022-03-16
Box_High_VoltageV3-_Meanwell
- reworked the high voltage box to fit a Meanwell SP200-24 power supply
- changed the hole for the SSR to fit better to the alternative power supply
- removed some holes at the split for an easier printing without support for the SSR hole
Cover_high_voltage_V3_1
- deepened the letters to 1mm and widened them 0,1mm at the edge so it's possible to press in the letters (i've expanded them to 1,2mm in z)
Cover_high_voltage_V3_2
- Widened and added additional air vents to make sure the power supply will get enough air
**Attention!
The low voltage box has to be reworked too, because of the changes made to the high voltage box regarding the SSR.**
Category: 3D Printers