Xbox One Thumbstick Replacement Cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Did your thumbstick cover tear while you were panic rolling? This is the print for you!
- Ocena
- 0 / 5
- Polubienia
- 28
- Pobrania
- 253
- Wydruki
- 0
- Wyświetlenia
- 980
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Share Alike
After some particularily heavy gaming I noticed the stock rubber cover on my left thumbstick was coming off, so I designed an FDM friendly-ish replacement that snaps on to the thumbstick base, I included some sacrificial supports but additional underside support is recommended. Results are quite good if you have a steady hand, use flushcutters to cut away the supports from the edge and then carefully peel off using pliers. Printed using dank old prusa PLA with a 0.4mm nozzle at 0.2mm layer height varying to 0.07mm layerheight for the top detail.
See the .3mf for my plate setup for the print pictured below, I recommend you use the same or a similar configuration.