Xbox One Thumbstick Replacement Cover
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Did your thumbstick cover tear while you were panic rolling? This is the print for you!
- Rating
- 0 / 5
- Likes
- 28
- Downloads
- 253
- Makes
- 0
- Views
- 980
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Video Games
- License
- Creative Commons — Attribution — Share Alike
After some particularily heavy gaming I noticed the stock rubber cover on my left thumbstick was coming off, so I designed an FDM friendly-ish replacement that snaps on to the thumbstick base, I included some sacrificial supports but additional underside support is recommended. Results are quite good if you have a steady hand, use flushcutters to cut away the supports from the edge and then carefully peel off using pliers. Printed using dank old prusa PLA with a 0.4mm nozzle at 0.2mm layer height varying to 0.07mm layerheight for the top detail.
See the .3mf for my plate setup for the print pictured below, I recommend you use the same or a similar configuration.