BLTouch & Tronxy AutoLevel Mount for V6 and Volcano
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
BLTouch and/or Tronxy AutoLevel Mount for V6 and Volcano.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 407
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Tested with Volcano, BLTouch mount work.
Works with Tronxy_X5SA_Hemera_Mount_V2_withoute_levation.stl from https://www.printables.com/model/223396-tronxy-x5sa-hemera-mount/files
Not Tested, but should work:
-Volcano & Original Tronxy ABL
-V6 & Original Tronxy ABL
-V6 & BLTouch
BLTouch:
With V6 mount it like the first Picture
With Volcano mount it like the second Picture
BLTouch to Nozzle should be (X) (-)39mm and (Y) (+)3mm (measured after installing BLTouch V3.1)
Origian Tronxy AutoLevel to Nozzle should be (X) 39mm and (Y) 0mm
But make sure to check this!!!
Hemera V6/ Volcano Part Cooling Duct & Mount https://www.thingiverse.com/thing:4042492
- Update (05.15.21)
ADD: ABL BLTouch V1.2 short reinforced (ABL BLTouch V1.2 Short breaks after first test)
- Update (05.28.21)
BLTouch Mount (ABL BLTouch V1.2 short reinforced) tested with Volcano, doesn't mount as considered. Work with Volcano but not how it should (BLTouch mountet at the ABL BLTouch V1.2 short reinforced only with one screw) New design is being considered
ADD: ABL BLTouch V1.3 (ABL BLTouch V1.2 short reinforced, bltouch was moved a bit in the middle to mount the srews)
Changed: BLTouch to Nozzle, X change from 41.75 to 39.2
- Update (05.30.21)
ADD: New BLTouch Design (ABL_BLTouch_V1.4.1 and ABL_BLTouch_V1.4.2)
Change: BLTouch X to Nozzle, X change from 39.2 to (-)39 | BLTouch Y to Nozzle, Y change from 0 to (+)3 |
Category: 3D Printer Parts