Universal Handlebar Phone Mount | Harness System
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Harness system for any smart phone, big or small, case or no case, to mount onto handlebars up to 26mm in diameter.
- Ocena
- 0 / 5
- Polubienia
- 27
- Pobrania
- 85
- Wydruki
- 0
- Wyświetlenia
- 1328
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Universal Handlebar Phone Mount | Harness System
For ANY Phone With/Without Cases
A, REDESIGNED, simplified version of the mount I use on my motorcycle.
Maximum handlebar diameter of 26mm
Required/Recommended Filaments:
Flexible Filament - Harness, Phone Pad, Bar Pad, Ripcord - .2mm LH
ASA - Upper, Lower, Clamp - .3mm LH
All parts are oriented as they should be printed
Harness / Protection - Required for each phone mount
PP-18022 Pad, Phone
H-L-18022 Harness, Large
or
H-S-18322 Harness, Small
Rc-18022 x2 Ripcord
PB-18022 Pad, Bar
MTB-HS22 - Trails
U-MTB-18322 Upper
UC-MTB-18322 Upper Clamp
L-MTB-18322 Lower
LC-MTB-18322 Lower Clamp
Additional Parts required - 2x M4x20mm/Nut, Small zip-tie
C-HS22 - Streets
U-C-18122 Upper
L-C-18122 Lower
Cc-C-18122 C-Clamp
Additional Parts required - M4x20mm/Nut, Small zip-tie
Z-HS22 - Streets/Trails - Depending on zip-tie
U-Z-18022 Upper
L-Z-18022 Lower
Additional Parts required - 1-2x Lg/Md zip-tie, Small zip-tie
Quick access 'Harness' works with large/small phones with/without cases
Adjustable 'Harness' keeps phone in place for bumpy trail rides
Protective Pad for handlebar mount/rotation prevention; can be trimmed to size
Protective Pad for phone contact surface; foam/neoprene/rubber can be added for increased "bounce" protection
Simple M4 bolt/nut or zip-tie mounting options
Zip-tie redundancy for filaments with poor layer adhesion properties; e.g. ASA
Sliding portions are angled at 55° and don't need supports
Phone pad requires no supports
Recommend: DO NOT use supports in the tunnels for the clamp and zip-tie, or any minor bridging
ASA is recommended for its UV resistance, Clamps can be printed with stronger filaments if desired
Harness-Large is for large phones with/without case, and small phones with case
Harness-Small is for small phones with no case
Stringing on Harness can be cleaned up with a dremel on a low setting and a sanding head
Remember to print 2x Ripcords
When securing mount to handlebar: press M4 nut into clamp, to help prevent it from rotating
When securing a phone in place: it helps to have one hand pulling the Ripcord while the other hand pinches the two tabs together.
To remove Harness from mount: use pliers at "cross-beams", then rotate, then pull out of slot