Universal Handlebar Phone Mount | Harness System
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Harness system for any smart phone, big or small, case or no case, to mount onto handlebars up to 26mm in diameter.
- Rating
- 0 / 5
- Likes
- 27
- Downloads
- 85
- Makes
- 0
- Views
- 1,328
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Universal Handlebar Phone Mount | Harness System
For ANY Phone With/Without Cases
A, REDESIGNED, simplified version of the mount I use on my motorcycle.
Maximum handlebar diameter of 26mm
Required/Recommended Filaments:
Flexible Filament - Harness, Phone Pad, Bar Pad, Ripcord - .2mm LH
ASA - Upper, Lower, Clamp - .3mm LH
All parts are oriented as they should be printed
Harness / Protection - Required for each phone mount
PP-18022 Pad, Phone
H-L-18022 Harness, Large
or
H-S-18322 Harness, Small
Rc-18022 x2 Ripcord
PB-18022 Pad, Bar
MTB-HS22 - Trails
U-MTB-18322 Upper
UC-MTB-18322 Upper Clamp
L-MTB-18322 Lower
LC-MTB-18322 Lower Clamp
Additional Parts required - 2x M4x20mm/Nut, Small zip-tie
C-HS22 - Streets
U-C-18122 Upper
L-C-18122 Lower
Cc-C-18122 C-Clamp
Additional Parts required - M4x20mm/Nut, Small zip-tie
Z-HS22 - Streets/Trails - Depending on zip-tie
U-Z-18022 Upper
L-Z-18022 Lower
Additional Parts required - 1-2x Lg/Md zip-tie, Small zip-tie
Quick access 'Harness' works with large/small phones with/without cases
Adjustable 'Harness' keeps phone in place for bumpy trail rides
Protective Pad for handlebar mount/rotation prevention; can be trimmed to size
Protective Pad for phone contact surface; foam/neoprene/rubber can be added for increased "bounce" protection
Simple M4 bolt/nut or zip-tie mounting options
Zip-tie redundancy for filaments with poor layer adhesion properties; e.g. ASA
Sliding portions are angled at 55° and don't need supports
Phone pad requires no supports
Recommend: DO NOT use supports in the tunnels for the clamp and zip-tie, or any minor bridging
ASA is recommended for its UV resistance, Clamps can be printed with stronger filaments if desired
Harness-Large is for large phones with/without case, and small phones with case
Harness-Small is for small phones with no case
Stringing on Harness can be cleaned up with a dremel on a low setting and a sanding head
Remember to print 2x Ripcords
When securing mount to handlebar: press M4 nut into clamp, to help prevent it from rotating
When securing a phone in place: it helps to have one hand pulling the Ripcord while the other hand pinches the two tabs together.
To remove Harness from mount: use pliers at "cross-beams", then rotate, then pull out of slot