KP3S Titan - DragonFly Adaptor
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Allows using a Dragonfly Hotend by unscrewing the groove mount and using the bolts.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 54
- Wydruki
- 0
- Wyświetlenia
- 1153
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Necessary as the groove mount of the DFly is slightly smaller than the clone-titan on the KP3S, which leads to a lot of wobble.
BOM - 3x 2.5mm screws of 4 or 5mm length. Only 3 are needed, since the 4th interferes with the closing of the titan's front
Note - This is a tight fit. It will seem like you cant close the lid of the titan, but keep slowly screwing in each of the 3 screws and it will fit snuggly.
This uses a remix of another clone-titan groove adapter.
Update: The V2 makes sure the DFly is actually aligned with the cables pointing back/forward which makes it easier to fit in certain cooling solutions (i.e. v6 coolers). You may need shorter M2.5 screws as the stock ones are too long with the current groove mount.
Unless you have a specific need, the original version should be good enough