1 / 2
Dual 80mm fan to 3" outlet — zdjęcie 1
1 / 2

Dual 80mm fan to 3" outlet

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Directs air from 2x 80mm fans through a 3" dryer hose line

Ocena
5 / 5
Polubienia
9
Pobrania
74
Wydruki
1
Wyświetlenia
501
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

BOM:

  • 8x M3 heatsets
  • 8x M3x8-10 SHCS
  • 2x 80mm fans
  • 3" dryer hose (plastic / flexible, not tested on rigid metal line)
  • zip ties - to hold hose in place

Designed for PLA.  Print with the flat fan face plate down, and it should print fairly well without supports.  I printed at 0.2mm.  Not sure how the curves of the outlet would fair at higher layer heights.  Heatsets & screws hold the fans in at four points each.  Two per fan is probably enough.  Fan grills aren't included in this model.  The ones I printed have a bit too much bevel and overlap each other, but it was good enough for my needs.

I use this to extract fumes from a laser cutter and vent them outside through an extra dryer outlet in my basement.

Contact [email protected] or Twitter @Pendorbound.
 

Tagi