1 / 2
Dual 80mm fan to 3" outlet — image 1
1 / 2

Dual 80mm fan to 3" outlet

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Directs air from 2x 80mm fans through a 3" dryer hose line

Rating
5 / 5
Likes
9
Downloads
74
Makes
1
Views
501
Reviews
1

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution — Noncommercial — Share Alike

BOM:

  • 8x M3 heatsets
  • 8x M3x8-10 SHCS
  • 2x 80mm fans
  • 3" dryer hose (plastic / flexible, not tested on rigid metal line)
  • zip ties - to hold hose in place

Designed for PLA.  Print with the flat fan face plate down, and it should print fairly well without supports.  I printed at 0.2mm.  Not sure how the curves of the outlet would fair at higher layer heights.  Heatsets & screws hold the fans in at four points each.  Two per fan is probably enough.  Fan grills aren't included in this model.  The ones I printed have a bit too much bevel and overlap each other, but it was good enough for my needs.

I use this to extract fumes from a laser cutter and vent them outside through an extra dryer outlet in my basement.

Contact [email protected] or Twitter @Pendorbound.
 

Tags