Vibration reducing corner pieces for (feet) rigidbot.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
There are a few other ones on here for the rigidbot but I wanted to tweak them a little. I liked the one that went…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 132
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
There are a few other ones on here for the rigidbot but I wanted to tweak them a little. I liked the one that went into the corner peices. The mod I did was to create a lip on the bottom to help keep the pads centered. Additionally because I have the rigidbot big it is heavier so I had to buy the "acoustifeet" ACF3007-25B which were slightly larger than the bottom of the original design but can handle weights up to 48.5 lbs (22kg). Just because all the weight I would recommend a 30% infill. Because of the lip on the bottom there is support material underneath but the lip is only 2mm thick so my support material removed cleanly, actually one of the best I have had!
Instructions
30% infill
Category: 3D Printer Parts