Mini Spinning Top Lite
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A lite version of my Ultimate Mini Spinning Top that fits in every pocket and doesn‘t require a bearing
- Ocena
- 4,938 / 5
- Polubienia
- 141
- Pobrania
- 715
- Wydruki
- 19
- Wyświetlenia
- 3213
- Oceny
- 16
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial
Introduction
I've remixed my Ultimate Mini Spinning Top so you can use up the rest of the steel balls from the 8x22x7 ball bearing. Ideally you have a 4 mm or a 5 mm steel ball for this design. If you don't have a bearing at hands there is also a version which does not require a steel ball.
Print Settings
- 0.1 - 0.15 mm layer height (0.1 mm recommended)
- 3-4 perimeters
- >20 % infill (heavier tops typically spin longer)
- make sure “Thin walls” is checked
You'll get the best looking results if you print the parts sequentially
Assembly Instructions
The top and bottom part should fit snugly in the ring (you may also use some glue). If the fit is too loose or to tight, just scale the ring by 0.5-1 % accordingly.
Give it a good spin!
Happy Printing