608 Pulley - allows cable up/down through hole(s) in whatever the pulley is mounted to
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This remix fixes two things original did not address: allow cable up/down through hole(s) in surface, and wheel too big.
- Ocena
- 5 / 5
- Polubienia
- 61
- Pobrania
- 404
- Wydruki
- 4
- Wyświetlenia
- 1648
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
Summary
This remix fixes two things the original did not address: needed to allow cable to pass up/down through hole(s) in surface to which the pulley is mounted, and the wheel itself was too large.
Details
@hedberg: thanks for the helpful listing!
This remix has two changes from the original: one change to base (needed for my setup) and one improvement to the wheel.
- I revised the bottom of the base to allow for the cable coming and/or going through a hole in the surface of whatever the base is attached to. See pics for actual example showing why I needed that.
- The wheel part provided in the original listing was substantially larger than shown in the photos of that listing, such that the outer edges of its ridges actually scraped against my base so tightly that the wheel could not spin. I had to sand quite a bit off of the ridges to get the wheel to spin freely. So in this remix, I reduced the outer size of the wheel down to 92% of original, while maintaining the hole size in the middle for the 608 bearing.
Thanks again, @hedberg! Much appreciated!
Update
As of July 4, 2022, the original posting now has a revised, smaller wheel. My wheel in this remix has been revised to match the same diameter as the updated wheel on the original listing.
My PayPal tip jar: https://paypal.me/design8studio
Various LowRider 3 CNC remixes:
View all my models and remixes on Printables:
*Amazon product links are affiliate links.