Fast Bridge and Retract test part, also for temperature
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Needs only 20 minutes and 2g of filament
- Ocena
- 5 / 5
- Polubienia
- 48
- Pobrania
- 630
- Wydruki
- 5
- Wyświetlenia
- 2080
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Fast Bridge and Retract test part
If you like it --> press like it :-)
Have searched for a model with which i can fast check good settings for temperature, the fan or retract. Found a lot of Temp towers but they took nearly 3 hours for printing and a lot of material…thats awesome.
Here you have minimal material use, bridge length of 20, 30 and 40mm and it´s made for five different parameters.
Change your parameter each 3mm height, you need not to look for the height of a base plate.
I used it for the fan (0% at start and added 20% each step) and retract parameters (1mm at start and added 1mm each step) and the print time was with 0,2mm layer height around 20 minutes! Printed with 3 Walls and 10% infill → only 2g / 0,7m !
Would be happy to see your makes!