Fast Bridge and Retract test part, also for temperature
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Needs only 20 minutes and 2g of filament
- Rating
- 5 / 5
- Likes
- 48
- Downloads
- 632
- Makes
- 5
- Views
- 2,086
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Test Models
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Fast Bridge and Retract test part
If you like it --> press like it :-)
Have searched for a model with which i can fast check good settings for temperature, the fan or retract. Found a lot of Temp towers but they took nearly 3 hours for printing and a lot of material…thats awesome.
Here you have minimal material use, bridge length of 20, 30 and 40mm and it´s made for five different parameters.
Change your parameter each 3mm height, you need not to look for the height of a base plate.
I used it for the fan (0% at start and added 20% each step) and retract parameters (1mm at start and added 1mm each step) and the print time was with 0,2mm layer height around 20 minutes! Printed with 3 Walls and 10% infill → only 2g / 0,7m !
Would be happy to see your makes!