Simple buffer spool for Ikea+365 10.6l
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Filament spool with simple buffer (for unloading from MMU) to fit Ikea365+ 10.6l air tight container.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 1473
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Yet another filament spool holder with inbuilt buffer for MMU units like ERCF or Prusa MMUs.
I took inspiration from a number of existing designs and numerous design iterations of my own. My latest iteration (this model) takes the buffer concept from https://www.reddit.com/r/3Dprinting/comments/e334zy/i_developed_a_reliable_simple_low_friction_spool/ and the Ikea fit from somewhere a long time ago (let me know an I'll attribute).
My requirement was to fit an Ikea 365+ 10.6l air tight container and accommodate the following:
- Silica container with slot for common hygrometer
- Built-in buffer that uses simple mechanism to reduce friction and avoid tangles
- Easy to load and unload a new spool
- Simple to print and assemble
- Fit a 1kg ABS spool from PolyMaker PolyLite ABS. This is 200mm outer diameter and 68mm wide. This model should be able to take up to 205mm x 85mm spools - maybe even a little more.
Required hardware
- 4x 608 bearings for the 2 filament “rods” that the filament spool will rest on
- 1x 608 bearing for the guide wheel that is sandwiched between the “Base” and “Top” pieces
- 1-2cm PTFE tube (4mm OD with either a 2.5 or 3 mm ID). This goes into the feeder next to the wheel for guiding the filament from the spool onto the wheel
- 1x M3x8 or M3x10 SHCS for fixing the Tangle Blocker “Catch” to the “Upright”
- 4x M3x20 or M3x25 for joining the “Top” to the “Base”
Print settings
These were designed and printed with ABS, but cannot see why it wouldn't work for PLA or other.
18% infill seems strong and sturdy enough. Suggest a high infill (even 100%) for the “rods” that support the spool.
Supports for Tangle Blocker “Upright” can be a tricky thing to clean up, be patient and gentle.
Assembly
Refer to the photos and renders. The renders show each printed part in a different colour to aid in assembly.
Feedback
I'm still not satisfied - I find the buffer aspect works well and reliably enough, but I'm still keen to reduce the friction and strain further.
It's light when loading from the buffer, but still too heavy for my liking when loading off the spool, especially for my ERCF.
If you have any ideas to further improve, please leave some comments.