FT Arrow Lightweight Power Pod
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
It's a 3D-printed center section for a Flitetest FT-Arrow plane.
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 837
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
Hi, I created a lightweight Power Pod and Nose for my FT-Arrow.
This Power Pod is wider than the original (56 mm) so it can accommodate larger battery packs.
The only thing you need to change is to trim a bit of foam in the center section to fit well.
I also included a 3D-printed nose to help with impacts ;)
Power Pod supports 16x19 and 16x16 motor mounts (most of quad motors will fit) and weights just 16.3g when printed with PET-G.
Nose weight is 13.8g.
You can also print a bottom plate that helps keeping battery strap in place.
Main section is much bigger than stock and balances great with 3S and 4S batteries:
3S 1300mAh 125g
4S 1000mAh 132g
4S 1300mAh 168g
4S 1800mAh 210g
I'm running DYS SunFun 2207 2750kV and LittleBee 30A ESC (with copper heatsink).
I managed to fly it at max 172km/h (106mph - ground speed of onboard GPS) with 4S 1800mAh setup. I used Gemfan Flash 6042 dual blade prop for setting speed records.
Be aware that above setup pulled over 65A at 4S ;)
I hope you will enjoy this plane as much as I do :)