1 / 9
Adapter, Bontrager Blendr saddle to Topeak bag — zdjęcie 1
1 / 9

Adapter, Bontrager Blendr saddle to Topeak bag

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Some Bontrager saddles feature 2 M5 tapped holes, which is nice for mounting all sorts of things. Here is Bontrager…

Ocena
0 / 5
Polubienia
3
Pobrania
35
Wydruki
0
Wyświetlenia
766
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Some Bontrager saddles feature 2 M5 tapped holes, which is nice for mounting all sorts of things.

Here is Bontrager Blendr Saddle Accessory Mount which uses these hardpoints.

I have a Topeak saddle bag which I wanted to mount. Because I use a non-offset seatpost & my saddle is largely slid forward, it typically wouldn't mount anyways because the front of the bag would interfere with the back of the seatpost.

However, I can solve both problems at once:

  • the bag mount is offset to the rear by almost 40-50 mm from the stock mount (this offset turned out to be perfect on the first try)
  • the 2-bolt pattern allows me to circumvent the original Topeak adapter entirely

Note that this print is effectively supporting the weight of the bag & all its contents, so it should be printed for more strength.

As a bonus, I sandwiched a piece of plastic salvaged from a push lawnmower clippings bag as a fender. I used a zip tie to force a curve in the plastic in order to stiffen it against drooping into my rear wheel. I simply drilled M5 clearance holes in the plastic. It's a better solution than the Ass Savers you can buy.

First revision

Note also that I needed to sand the slanted face of the mount down to get the clip to engage. I think the slot also needs to be a bit larger. It's tight now, but with repeated use I trust it will get looser. Until then, the tightness improves security of the bag mount.

Second revision improvements

I've loosened the slots a bit in my fifth revision (second Solidworks revision), also posted.

This version is untested.

Category: Other

Tagi