Shutter Precision/Exposure Dynamo Hub Connector
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
http://www.sp-dynamo.com/8Xseriesdynamo%20hub.html http://www.sp-dynamo.com/8-series-pic/connect-installation.pdf…
- Ocena
- 5 / 5
- Polubienia
- 23
- Pobrania
- 287
- Wydruki
- 1
- Wyświetlenia
- 1032
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
http://www.sp-dynamo.com/8Xseriesdynamo%20hub.html
http://www.sp-dynamo.com/8-series-pic/connect-installation.pdf instructions for connector installation.
I have an Exposure (rebrand of Shutter Precision) PD-8X 6V, 3W dynamo hub, for which I got exactly one contact housing & connector.
Took the best measurements I could with calipers; they're very small pieces & therefore hard to measure.
I didn't take any special measures for 3D printing; just exactly what I read off of the pieces. Highest resolution/layer height would be recommended.
I am particularly concerned about whether or not the snap fit will work.
Untested. Let me know if you do test it.
Update: see the last picture. Pictured on the bottom is a Shimano dynamo hub connector. The top row are the respective SP connector components. As far as I can tell, without taking measurements they should both work the same. The SP one is a bit wider (so the interface to an actual SP hub would be nicer), but the actual connection should be the same. Shimano may be speccing slightly smaller wires.
Category: DIY