Anycubic Kobra Z-Axis Dust Cover Grease Protector
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An upgrade that shields the z-axis screw area preventing dust from getting in extending the life of the z-axis assembly.
- Ocena
- 4,75 / 5
- Polubienia
- 61
- Pobrania
- 398
- Wydruki
- 6
- Wyświetlenia
- 1672
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A simple quick print that shields the area around the z-axis screw preventing dust and debris from getting into the grease lubricant. This will prolong the life of your z-axis assembly.
Uses the pre-existing cable holder hardware to secure itself.
Printed with no supports at 0.15mm layer height and slowly (around 30mm/s).
Some minor sanding may be required to the z-axis hole if your print results in poor tolerances.
During assembly make sure there is a very small gap around the whole of the z-axis screw to ensure the cover does not drag on the z-axis during printing. Pack the inside with grease when installing.
Printed on Anycubic Kobra using Anycubic Green PLA.