1 / 3
Bearing - 8x12x3 - OpenRC F1 Front Wheel — zdjęcie 1
1 / 3

Bearing - 8x12x3 - OpenRC F1 Front Wheel

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Spacer bearing for the OpenRC F1 front wheels (size: 8x12x3). If you won't actually be driving your RC, this is for you.

Ocena
5 / 5
Polubienia
23
Pobrania
260
Wydruki
7
Wyświetlenia
1018
Oceny
6

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution

I have some OpenRC F1 cars that are only being displayed and won't be driven (anymore). I didn't want to waste actual bearings by having them sit on the car, but the bearings are required for the wheels and axels to fit together correctly. 

I made these “bearings” to replace the front wheel 8x12x3 bearings. These will not hold up if you actually try and drive your car, they are only for allowing you to put it together without purchasing bearings. 

The interior hole is slightly larger than normal and the outer diameter is slightly smaller. This is done on purpose to allow the wheels to still spin if the car is pushed along. 

Note that these are for the front wheels only. You will need to print 2 for each wheel. I have a separate model for the rear wheels. I am posting them separate as people may have a use for these bearings/spacers outside of OpenRC.

The rear wheel bearings can be found here: https://www.printables.com/model/244948-bearing-12x18x4-openrc-f1-rear-wheel

Tagi