Desiccant Jar (Fast Vase Mode)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Jar with vented sides for filament drying desiccant beads. Fast print using spiral vase mode.
- Ocena
- 4,6 / 5
- Polubienia
- 97
- Pobrania
- 541
- Wydruki
- 13
- Wyświetlenia
- 2537
- Oceny
- 10
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a remixed version of my Part Jars with vented sides for holding desiccant beads to dry filament. The 54mm diameter x 52mm tall container should fit inside most spool holders.
The container and lid print fast using spiral vase mode. The side vent design was derived from this video: Hacking Vase Mode - 3D Printing Experiments
There are two versions of the container, with or without bottom vents. The lid is vented but a solid lid version is available here.
The bottom layer vents are recessed 0.6mm assuming a 0.2mm layer height with 3 bottom layers.
Print Settings:
- Material: PLA
- Nozzle: 0.4mm
- Layer Height: 0.2mm
- Line Width: 0.5mm <== Important
- Perimeters: 1
- Bottom Layers: 3
- Infill: None
- Supports: None
- Bed Adhesion: Skirt
- Spiral Vase: Enabled (Prusa Slicer setting)
- Spiralize Outer Contour: Enabled (Cura setting)
- Smooth Spiralized Contours: Disabled (Cura setting)
- Printing Orientation: Jars bottom-side down, Lids top-side down