1 / 1
8mm rod holder for 20mm extrusions - Tronxy X5SA — zdjęcie 1

8mm rod holder for 20mm extrusions - Tronxy X5SA

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Holds rods in place without depending on Z height

Ocena
0 / 5
Polubienia
13
Pobrania
65
Wydruki
0
Wyświetlenia
677
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

The Tronxy X5sa has a little gap on the linear rods for the z axis, and if you miss a little info on the assembly instructions you can end with a slightly bowing Y axis that will make bed leveling highly annoying. 

Since I forgot the spacers and am too lazy to disassemble everything I printed those on a different printer.

Use the screws on top to make sure the rods are centered, then squeeze those holders on each side, and then loose or remove the top screws.

Needs 1 M5x10 screw, and a T or square nut to affix to the extrusion. Step file included.

Tagi