1 / 1
8mm rod holder for 20mm extrusions - Tronxy X5SA
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Holds rods in place without depending on Z height
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 65
- Makes
- 0
- Views
- 677
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The Tronxy X5sa has a little gap on the linear rods for the z axis, and if you miss a little info on the assembly instructions you can end with a slightly bowing Y axis that will make bed leveling highly annoying.
Since I forgot the spacers and am too lazy to disassemble everything I printed those on a different printer.
Use the screws on top to make sure the rods are centered, then squeeze those holders on each side, and then loose or remove the top screws.
Needs 1 M5x10 screw, and a T or square nut to affix to the extrusion. Step file included.