Mining Rig 120mm fan joiner bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I needed to mount 6 - 120mm fans side by side on the front of the mining rig I built. I could not find any brackets…
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 95
- Wydruki
- 0
- Wyświetlenia
- 1036
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
I needed to mount 6 - 120mm fans side by side on the front of the mining rig I built. I could not find any brackets that would hold the fans and then allow me to screw them to the face of the rig. I made these flush mount brackets. 1 set (top and bottom) will hold 2 fans together side by side. Photo coming with the brackets in use.
Note:
I would print them more than 50% infill. Reason for it is these were 20% and as you can see the screw heads crushed the surface a bit.
Also someone made a single: https://www.thingiverse.com/thing:2756758
Category: Electronics