Modular Spray Can Rack
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Easy to print modular spray can rack. No supports needed. The rack can be fitted to a wooden or MDF base using self…
- Ocena
- 3 / 5
- Polubienia
- 57
- Pobrania
- 147
- Wydruki
- 0
- Wyświetlenia
- 1453
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
Easy to print modular spray can rack. No supports needed. The rack can be fitted to a wooden or MDF base using self tapping screws and the sides and brackets can be fastened with M3x15 or M3x25* screws and nuts. The sides will need to be glued to the horizontal "gasket like" part but the parts feature dove tail cuttings to make this easier.
The tri-hexagonal pattern was obtained by using a top and bottom skin height of zero in Cura, along with a wall width of 4mm. You can use your preferred infill (I set it to 50% with a 0.8mm nozzle) to get your preferred pattern. I wish Cura had a honey comb infill pattern.
If you like the design, print it and find it useful, please share your make.
*you can tie two modules side by side using a single pair of screws.
Print Settings
Printer Brand:
Creality
Printer:
CR-10S
Rafts:
No
Supports:
No
Resolution:
0.4 with 0.8mm Nozzle
Infill:
50%
Notes:
You can set the top and bottom skin heights to zero to reveal the infill pattern. Wall width was set to 4mm.
Category: DIY