Bitcoin Phond Stand

**Revised Files and Helpful Printing Data**

It's better printed on its side instead of right-side up.  Recommend using the following perimeters for the 'Bitcoin CPS Body' file:

1. Quality:  Standard or Higher
2. Wall Thickness:  0.8
3. Wall Line Count:  2
4. Infill Density:  10%
5. Infill Pattern:  Line

If using Translucent Filaments (See Pictures) for the 'Bitcoin CPS Body' to get a “see-through” look, use these perimeters:

1. Quality:  Standard or Higher
2. Wall Thickness:  1.2
3. Wall Line Count:  3
4. Infill Density:  0%
5. Infill Pattern:  N/A
6. Print Speed:  25-35 mm/s

Only use supports (line at 5% Support fill) at the gapped space on the mounting plate, where the charging cord rises up from the bottom.  While printed on its side, no supports are required on the 'Bitcoin CPS Body' for the letters, logo, circle, nor the two slots at the bottom where the charging cord slides through.

*No sanding is required for the ‘Bitcoin Letters’ if you print using the following perimeters in Cura:

1.       Standard Quality or Higher
2.       Wall Line Count:  1
3.       Top/Bottom Thickness: 1.0 mm
4.       Infill Density: 100% (for strength when you push it in with your fingers)
5.       Print Speed:  35 mm/s
6.       Wall Speed:  20 mm/s

**Only a little sanding is needed for that notch created from the filament (FDM type) on the 'Bitcoin Circle of Logo'.