Nerf Dart Compatible Drain Blaster
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An adapter which makes it possible to shoot Nerf Darts with a drain blaster through special capsules.
- Ocena
- 0 / 5
- Polubienia
- 30
- Pobrania
- 109
- Wydruki
- 0
- Wyświetlenia
- 2336
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial
An adapter which makes it possible to shoot Nerf Darts with a drain blaster through special capsules.
WARNING:
DO NOT AIM OR SHOOT AT HEAD OR EYES!
USE AT YOUR OWN RISK!
Print instructions
Printing:
1st Side:
Print on the side that connects to the drain blaster
Use supports
50% infill
4 perimeters
2nd Side:
Print on the side that connects to the drain blaster
Use supports
50% infill
4 perimeters
Single Shot Capsule:
Print on the side that connects to the adapter
Use supports
5% infill
4 perimeters
Triple Shot Capsule:
Print on the side that connects to the adapter
Use supports
5% infill
4 perimeters
Ten Shot Capsule:
Print on the side that connects to the adapter
Use supports
5% infill
4 perimeters
Assembly:
Materials you will need:
6 m3 screws 25mm or cut to fit
6 m3 nuts
12 3mm washer
1 15mm×2,5mm o-ring
2 60mm×2,5mm o-rings(per capsule)
Main Blaster:
Put the drain blaster between the 1st and 2nd side.
Put a washer on each screw and screw them in.
Before you put the nut on, place another washer on the screw so that there is a washer on each side.
Put the nuts on and tighten them.
Then place the small o-ring in the slot on the small connector piece.
Capsule:
Put the two big o-rings in the slots for the o-rings.
WARNING:
DO NOT AIM OR SHOOT AT HEAD OR EYES!
USE AT YOUR OWN RISK!