Nerf Dart Compatible Drain Blaster
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An adapter which makes it possible to shoot Nerf Darts with a drain blaster through special capsules.
- Rating
- 0 / 5
- Likes
- 30
- Downloads
- 109
- Makes
- 0
- Views
- 2,336
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Toys
- License
- Creative Commons — Attribution — Noncommercial
An adapter which makes it possible to shoot Nerf Darts with a drain blaster through special capsules.
WARNING:
DO NOT AIM OR SHOOT AT HEAD OR EYES!
USE AT YOUR OWN RISK!
Print instructions
Printing:
1st Side:
Print on the side that connects to the drain blaster
Use supports
50% infill
4 perimeters
2nd Side:
Print on the side that connects to the drain blaster
Use supports
50% infill
4 perimeters
Single Shot Capsule:
Print on the side that connects to the adapter
Use supports
5% infill
4 perimeters
Triple Shot Capsule:
Print on the side that connects to the adapter
Use supports
5% infill
4 perimeters
Ten Shot Capsule:
Print on the side that connects to the adapter
Use supports
5% infill
4 perimeters
Assembly:
Materials you will need:
6 m3 screws 25mm or cut to fit
6 m3 nuts
12 3mm washer
1 15mm×2,5mm o-ring
2 60mm×2,5mm o-rings(per capsule)
Main Blaster:
Put the drain blaster between the 1st and 2nd side.
Put a washer on each screw and screw them in.
Before you put the nut on, place another washer on the screw so that there is a washer on each side.
Put the nuts on and tighten them.
Then place the small o-ring in the slot on the small connector piece.
Capsule:
Put the two big o-rings in the slots for the o-rings.
WARNING:
DO NOT AIM OR SHOOT AT HEAD OR EYES!
USE AT YOUR OWN RISK!