Camera Arm for Logitech C920 for Prusa i3 Mk3s
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Camera Arm for Logitech C920 for Prusa i3 Mk3s You will need 1/4" Bolt and nuts. The one I used was 3/4inch in length.
- Ocena
- 4 / 5
- Polubienia
- 34
- Pobrania
- 310
- Wydruki
- 0
- Wyświetlenia
- 3173
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Camera Arm for Logitech C920 for Prusa i3 Mk3s
You will need 1/4" Bolt and nuts. The one I used was 3/4inch in length. This is the same ones you use for cameras.
You can get away with any other bolt similar size.
Print instructions
Please be careful when you print. Make sure you are printing on flat side down. There is a cable clip on one side. do not print on that side.
0.2mm is good enough for this print. This Camera arm is way better than most other camera arm, it is higher up and adjusted to the right angle, and not need to dissemble the C920.