Clip On Bit Holder for Hex Shafts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple bit holder that attaches to a hex shaft for handy carrying. Can also be used separated as a small bit driver.
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 62
- Wydruki
- 0
- Wyświetlenia
- 327
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
A simple bitholder that attaches to a standard sized hex shaft (same size as the bits themselves).
I needed some additional bits to go with my wera ratcheting screwdriver since it can only hold 6 bits in its internal compartment. Also i didn't want to lug around a separate bitholder so I designed this little thing that neatly attaches to the shaft of the screwdriver.
The holder can also be used as a small bitdriver by itself and has been pretty handy for getting screws to some tight spots.
Fit:
The fit might be a bit finnicky to get just right depending on the printer and the filament, so try scaling the model up/down just a tiny bit if the fit is too loose or too tight.
If the bits are just a bit too tight to pull out you might want to keep using it for a few days (the holder will loosen up a bit with use)
Filament:
I don't recommend using PLA for this since the holder need some flexibility to work correctly and PLA tends to loosen over time so you bits will start falling out after a while. So use PETG, ABS, ASA etc. if possible.