1 / 12
ZOHD Nano Talon Evo VTX and Antenna Mount — zdjęcie 1
1 / 12

ZOHD Nano Talon Evo VTX and Antenna Mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I wanted a clean way to mount the VTX and Antenna on my Nano Talon Evo. These parts mount to the underside of the…

Ocena
0 / 5
Polubienia
3
Pobrania
20
Wydruki
0
Wyświetlenia
269
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I wanted a clean way to mount the VTX and Antenna on my Nano Talon Evo. These parts mount to the underside of the nose/canopy lid and are out of the way of the battery etc. You'll need to cut a 17mm hole in the lid for the antenna mount. The VTX-holder sits on the ribs under the lid. Both are held on with a drop or two of CA. That VTX is 22mm wide and there is a groove in the holder to slide it into. It sits just behind the NACA duct so it stays cool during flight.

Print Settings

Printer Brand:

Anet

Printer:

A4

Rafts:

No

Supports:

Yes

Resolution:

200

Infill:

20

Filament: Filaments.ca PETG Black


Notes:

Supports on for VTX Mount. Low infil = low weight. Printed on an Anet ET4

Category: R/C Vehicles

Tagi