Mouse Ears - dissected
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Circles cut to allow placement outside the model and a brim around all. Aim is to stop warping of first layer.
- Ocena
- 5 / 5
- Polubienia
- 17
- Pobrania
- 320
- Wydruki
- 2
- Wyświetlenia
- 1485
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I have been working at 0.28mm layer heights for quicker print times, and slow prints with DarkWing Dad's slicer mods, but was still suffering with furthest corners lifting during longer print runs. If I went back to 0.20mm, I was looking to add 5 hours to a print for no discernible improvement in appearance, and not for something like a boardgame card storage box.
Finding the OP by Bowie Inc, but preferring not to have the ears be part of the model, the advice on https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-how-do-i-print-this-printing-help/how-to-print-brim-ears/ was helpful. Cutting the discs in to parts in Tinkercad and then adding to the Parts Gallery in PrusaSlicer. Leaving a gap between the ears and the model, and the brim on, the print is running.
I found that placing the ears close enough to the corner was helped if looking at the model from underneath in the slicer. The 0.20mm height of the 4 disks only added 1 minute to the run-time, with nothing else modified.