Mac Keyboard Grippy Feet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This must be printed with supports. I used the default Cura supports, but I think I would have had an easier time had…
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 51
- Wydruki
- 0
- Wyświetlenia
- 484
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This must be printed with supports. I used the default Cura supports, but I think I would have had an easier time had I gone with Tree supports. When I removed the supports, I did break a couple of the mushroom tabs off by accident, but the grippies have stayed on.
I used a clamp to press them into the mould filled with silicon caulk, then left it overnight, and gave them another hour or two to stop feeling tacky.
I used 3M stickers to adhere them to the keyboard.
The slope is ~4°, the front adds ~.25" (6.35mm) in height, and the rear adds ~.5" (~12.7mm) in height.
The pictures were taken after 3-4 months of daily use.
Category: Office