1 / 2
Skadis Holder: Flux Syringe and Pen Holder (uses heat set inserts) — zdjęcie 1
1 / 2

Skadis Holder: Flux Syringe and Pen Holder (uses heat set inserts)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Ikea Skadis holder for flux syringes and flux pens, using heat-set inserts and printed hooks for mounting

Ocena
5 / 5
Polubienia
38
Pobrania
210
Wydruki
1
Wyświetlenia
1738
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Share Alike

Skadis holder for 20.5mm diameter (or smaller) flux syringes (x3), 16.5mm diameter (or smaller) flux pens (x4) with extra slots/spaces for storing various other soldering tools. Most desoldering pumps fit into the syringe spaces just fine as well. 

Bonus slot to keep a biegelehre in a much deserved place of honor and respect, which brightens up any workbench. :)

This model requires M2.5 heat-set inserts, M2.5 screws, and printed hooks.

Required Parts

Printing Notes

Yep, this is a big print! It'll take a long time - about 18 hours on a MINI+ at 0.25 and over a day at 0.20. The printed one in the photo was printed at 0.20 in PETG without any supports, taking about 28 hours to complete, and it turned out beautifully.

For printing any heat-set insert project on a FFF/FDM printer its a good idea to use 4+ perimeters to make sure that there's enough surface for the inserts to bite into.

My test and final prints were done on a stock Prusa MINI+ with Prusament PETG. PLA and other materials should work fine though.

Tagi