Bracket to mount E3D V6 thermistor on MK3S+
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This bracket makes it possible to use the E3D thermistor which has coupling right next to the cartridge on the MK3S+
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 388
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
The original E3D V6 thermistor catridge is equipt with a Molex Micro-Fit 3.0 connector close to the cartridge. Together with the E3D High Precision Heater Cartridge, which has the same connector, it is possible to swap the hotend without unpluging the cables from the mainboard.
Unfortunatly, the wires from the thermistor cartridge to the connector are so short, that the connector would be in an unfunctional position under the extruder, where it might collide with printed parts.
My solution is to place the thermistor wires parallel to the fan wires through the extruder, so the thermistor connector can rest right next to the fan.
As a side effect, when you grab the heater block with pliers to change a nozzle, or if you want to install a silicon sock, the thermistor wires will no longer be in your way.
This bracket keeps the connector in the correct position and makes it possible to (un)plug the connector very easy.