Holding Rack with M3 screws for Modular Cress/Sprout Sieve/Farm V2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holding Rack with Standard M3 screws for the Modular Cress/Sprout Sieve/Farm V2 designed by NightHawk
- Ocena
- 5 / 5
- Polubienia
- 43
- Pobrania
- 162
- Wydruki
- 2
- Wyświetlenia
- 1223
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
I just wanted to have a Holding Rack for the Modular Cress/Sprout Sieve/Farm V2 with standard M3 screws. The designer NightHawk was so kind to share the step files for his connectors and spacers. In the end I designed a new stiffer rack based on his design with standard M3 screws instead of “self tapping, counter sunk screws” he used.
There are 2 files available:
1. farm_v2_rack - remix with ruthex M3.3mf - This File has a connector and a spacer with standard form ruthex m3 thread inserts which makes the whole rack very stable
2. farm_v2_rack - remix M3.3mf - This File has a connector and a spacer with normal m3 wholes. I found out that the screws have a good grip inside the filament even without the ruthex thread inserts. But after a few times of dismantling and reassembling, there could be problems because the screws have less grip over time.
You need to print 2 spacers and 4 connectors. If you want to extend your “initial” rack you need everytime additonally 2 spacer and then only 2 connectors.
Printing Instructions
- PETG, ASA or ABS recommended
- layer height 0.3mm
- No raft