Water Bottle Dryer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A water bottle dryer using a 120mm computer fan.
- Ocena
- 4,5 / 5
- Polubienia
- 61
- Pobrania
- 161
- Wydruki
- 2
- Wyświetlenia
- 2115
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Share Alike
Here is a water bottle dryer I've designed. Primarily for cycling water bottles but can be used for any type of bottle with a wide mouth. Yeti, RTIC, Hydroflask, & even Baby bottles, etc.
I made this so a 120mm computer fan is used to move a lot of air at such a low db volume you have a hard time hearing it. I also set this up with 2 USB connections so there wouldn't be a plug in power issue or outlet adapters. Just use one of the USB plug ins you already own.
I used a fan by Noctua that runs at 22.6 db to keep things quite.
https://a.co/bxNIvb8
The wire to connect the fan to the USB switch wire. I bought this 2 pack because I knew I'd be making more then one. This cable is available in a single pack as well.
The USB switch wire.
I Used PLA by, Duramic, Overture, Prusament, Hatchbox, & Geetech. I like the outcome and finish the most when using Overture PLA & PLA+ also Duramic PLA & PLA+
This is gonna be a long print taking about 28hrs with 10% infil & a small amount of supports.
If printing the STL file, Using supports for the front holes isn't really necessary because the flat part is close enough to bridge. Maybe a few lines might droop but it won't hurt & will save some time.