EC12 Low Profile Encoder Knobs
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Three styles (regular height, low pro, sub-keycap height) of FDM-printable encoder knob for EC12-style encoders
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 148
- Wydruki
- 1
- Wyświetlenia
- 1084
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
I was building a low pro keyboard and wanted to use some low pro encoders, the EC12s. However, the only knobs I could find were quite expensive. So, I designed my own knobs, intending them to be FDM-printable in their natural, top-up orientation.
They fit inside a single key's spacing on a choc-spaced board, to allow them to be used even on boards like the Hillside where the encoder subs in for a choc switch.
You may need to enable a bit of negative horizontal expansion in Cura or the equivalent setting in your preferred slicer to ensure that the knobs fit on the shafts; the design leaves just enough room assuming perfect dimensional accuracy. I found quite good results printing them at 103% scale rather than messing around with horizontal expansion, personally.
The third variant actually sits lower than a choc switch + keycap and was designed for Majyk Oyster on the splitkb.com Discord server.