Indoor plant pot grow light (LÄMP)

This model is inspired by my laziness, not to check the ceiling sockets in the bathroom. And buying a bulb with the wrong socket type. 

It's designed around the GU10 socket. 

Parts

For assembly you will need:

1 x GU10 Ceramic Bulb Socket
1 x GU10 LED Light Bulb, up to 7W on 230V
1 x  160cm Flat Power Cord
2 x long screws for the lamp
2 x 335mm tubes with a diameter of 13.7mm
1 x 2 Pin 250V 3A Boat Switch 8.5*13.5mm
2 x 350mm 6mm2 wires
Some heat shrink for 6mm2 wires

For parts print the following:

1 x LÄMP PÕHI.stl
1 x LÄMP TOOB ÜHENDUS_new_W_Switch.stl
1 x LÄMP kuppli kate.stl
4 x LÄMP kuppel.stl
1 x LÄMP kupli hoidja.stl

Assembly

PSA: Never work with mains voltage if you don't know what you are doing, that includes not having any experience or knowledge and the skill set to go with it.

Connect the “LÄMP PÕHI” with a tube and the “LÄMP TOOB ÜHENDUS_new_W_Switch”, attach another tube to it and cap it off with a “LÄMP kupli hoidja”. Then Insert the “Ceramic Bulb Socket” into the “LÄMP kuppel”, screw “LÄMP kuppli kate” on the “LÄMP kuppel” Insert the flat power cord into the back hole of the “LÄMP PÕHI” and pull it through the switch hole . Solder one of the power cord wires to the switch terminal and also solder one of the 350mm wires to the other switch terminal. Cover them with heat shrink. Solder the other 350mm wire to the other power cord wire and seal it with heat shrink. Pull the 350mm wires through the top tube. Connect the remaining wires with the Ceramic Bulb Socket and add heat shrink. Push the switch into it's little hole and you've got yourself a plant grow light with a bottom tray for the planter.

For fully assembled view of the model, see Assembly.stl