360 degree Lithophane holder (3mm)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hello every one. There are several lithophane designs available in thingiverse. So I decided to design a new one which…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 256
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
Hello every one.
There are several lithophane designs available in thingiverse. So I decided to design a new one which takes less time to print at better quality. This lamp is powered by 5V Mobile charger to glow the lithophane by 1 Watt LED. I thank to All lithophane designs makers in thingiverse. Because I truly inspired and got to know from their works. (Special Thanks to Jaymake)
This one 360 degree lithophane H = 44mm & Dia = 68 mm(Approx)
The complete design is easy to assemble. The components required and parts to be printed as follows
Sl No Parts to be printed Quantity in Nos
1 Top holder 1 no
2 Bottom Holder 1 no
3 Top holder Knob 1 no
4 If required washer to place LED 1 no
5 Lithophane 1 no
Sl No Components Required Quantity in Nos
1 Rocker Switch Small One 1 no
2 LED (1 W or similler) 1 no
3 Resistor 100 Ohm 1 no
4 Micro USB female connector. Panel mounting type 1 no
5 Heat shrink tube 4mm dia Req length
6 Favi stick
7 A mobile charger Micro USB type
Steps to follow:
• Use the attached JPEG as an original for the correct dimensions of the lithophane.
• Change the image to whatever you like (keep the format!)
• Go to http://3dp.rocks/lithophane/
• Upload your image
• Select "Outer Curve"
• Go to settings > Model settings > Maximum size (MM) > Set it to 200 mm
• Go to settings > Model settings > Curve > Set it to 360
• In case you did not upload a negative image: Go to settings > Image settings > positive image
• Click "Model" on top of the page
• Hit "Refresh" button
• Hit "Download" button to download and print your personal lithophane
Printing:
• All the parts not required support to print. The STL file once open in cura split the objects and keep one object at a time and print. Don’t print all the parts at a time which may cause poor quality of prints.
LET ME KNOW, IF YOU MADE ONE ;-)
Print Settings
Printer:
Anet A8
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.2 for lethophane
0.3 for all other parts
Infill:
20 - 30%
Category: Household