BK Logitech C510 Camera Mount w/ Lens Clip

This is a mount I designed for a Logitech C510 camera for use with OctoPrint. The mount is designed to fit a 17mm ball joint. If you are planning to use this... Please note that this will require slight disassembly of the C510 camera (specifically it's accordion mount) as it is intended to replace the entire base of the C510 and only keep the top (swiveling) part of the camera.

Once disassembled, the camera mounts onto the Ball Mount Base with the same screw that secured the top half of the camera to the lower mount. You will then attach it to a 17mm ball and use the Mount Nut to secure the mount to the ball joint.

I have also included two bases for mounting the arm to the front left of your Ender 3. However, please note that these were custom designed for arms I had on hand, and will likely need to be tweaked on your end to fit your arm.

In addition, I have also included a Lens Clip... This allows you to mount cheap lens attachments meant for cell phones to your camera to tighten the view and allow the camera to remain closer to the printer. It is not necessary to use these, but the long arm photo shows how far the camera must be without the lens attachments. The short arm shows how close the camera is with a wide angle lens adapter installed.

Feel free to let me know if you have any questions in the comments and feel free to post those makes should this help you.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

.3mm

Infill:

Filament: Jarees PETG Matte Black

Notes:

Category: 3D Printer Accessories