G502 charging dock

I created this model because i did not want to have to have a micro USB cable just for charging my mouse, most other stuff i have is USB-C

For the dock, you would need the following items:

• A USB cable (any old type A cable should work)
• 4 M3x6 screws for the bottom
• 2 M3 screws, they have to be magnetic and conductive, any length can work, you can cut or make the spacers larger depending on what you need

Assembly is easy, these are the steps:

• Grab the cable and cut the end, you will need to strip the insulation
• Strip the red and black wires
• Wrap the wires around the screws that portrude out of the puck (you can solder them if you like but that is not needed)
• Pass the screws through the main body and screw them into the puck (might need the spacers
• Red wire goes to the right, black goes to the left (refer to picture)
• Screws should portrude just a little bit (like the pictures
• You can test at this point and make sure it works
• If it works, attach the bottom with the M3x6

To hold it in place i used double sided tape to my desk, dont use VHB if you want to move it afterwards though

Feel free to remix the design if you like, if you have any questions, please let me know

Please add pictures if you modify the puck in any way