16 Minute RGB Remote Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Probably the cheapest rgb remote holder you can print
- Ocena
- 4,5 / 5
- Polubienia
- 53
- Pobrania
- 217
- Wydruki
- 3
- Wyświetlenia
- 786
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
Most filament saving rgb-led remote holder you will probably find.
Deisgned to be printed with 0.2mm Layerheight and 0.4mm Nozzle.
Also made a variation for 0.3mm but this one uses slightly more filament (3.6g vs. 3.08g) - on the other hand it will be a little more sturdy - also a bit quicker, just 12 minutes.
In the .3mf Prusaslicerfile you will find a premade modifier to have a surface to attach some double sided tape to the back of the holder. You can easily change the x-y-dimensions of the modifier to the size of the double sided tape that you want to use. Right now it is set to 4x2cm. Feel free to change infill density and pattern to your preference. Right now it is set to 15% rectilinear infill and works great. If you want the bakc to be solid, jsut delete the modifier and set infill to 100%.
If you do not want to tinker with the .3mf file here is what you should do:
- Disable top and bottom layers - except you want the back of your holder to be solid, in that case, no need to read further, happy printing! ;)
- Set infill pattern and density to your desire (for me rectilinear and 15% seemed completely sufficient)
- Add a 100% infill modifier to attach some double sided tape to the back (see the patch in the picture - modifier for only the first two layers [z=0.4mm] seemed to work just fine)
If you decide to go for another infill pattern I would love to see your results!
Happy printing :)
P.s. Wild approach: cut the model in half, even less filament and time used and should still work just fine.